DLE35RA DLE Engines DLE-35RA Rear Exhaust Gasoline w/EI

DLE35RA DLE Engines DLE-35RA Rear Exhaust Gasoline w/EI

Note: Graves RC Coupons are not applicable with this product  

DLE Engines DLE-35RA Rear Exhaust Gasoline w/EI 

High performance in a compact package
Rear exhaust for the perfect tuned pipe setup
Newly designed piston with re-engineered skirt for less piston weight resulting in such advantages as awesome throttle response, more power and longer engine life
Electronic ignition is the no-hassle answer to simpler starts, higher performance and minimal RF noise
Producing 400 more rpm than the DLE30, the DLE 35-RA comes with engine standoffs, electronic ignition, spark plug and muffler 

DLE 35-RA Gasoline Engine
Electronic Ignition
Muffler
NGK CM6 Spark Plug
Four Engine Standoffs with Mounting Hardware
Integrated Choke Rod Guide
Rear-mounted Carb
Instruction Manual 

• Gasoline with at least 87 octane rating 2-cycle oil, mix ratio for this engine is 30 parts gas to one part oil and must be followed exactly for warranty consideration and optimum performance 
• 4.8 - 12V battery for ignition (separate receiver style pack can be used) (LiPo & LiFe requires voltage regulator)
• Propeller and field equipment 

Displacement: 34.5 cc (2.13 cu in)
Bore: 1.5 in (38.5 mm)
Compression Ratio: 7.6:1
Static Thrust: 9.5kg Pulling Force/100 meters altitude 7.8kg Pulling Force/1,800 meters altitude
Gasoline/Oil Mixture: 30:1
Gasoline Octane Rating: 87
Recommended Propellers: 18x10, 19x8, 20x8, 20x10
Weight, engine: 2.06 lb (936 g)
Weight, muffler: 2.61 oz (74 g)
Weight, ignition module: 5.26 oz (147 g)
Output: 4.1 hp @ 8,500 RPM 

Carburetor Adjustments;
Low Speed Needle: 1.1 turns out as a starting point, adjust for a smooth idle and a reliable transition to high throttle
High Speed Needle: 1.5 turns out from closed, adjust needle to peak RPM, if engine slows or dies at full throttle, the high-speed mixture is likely too lean
Muffler Dimensions: 3.6 x 2.3 x 1.3" (92 x 58 x 33mm)
Exhaust Outlet Length: 1.9" (48.5mm)
Exhaust Outlet Diameter: 0.63" (16.1mm)
Distance Between Mounting Hole Centers Same Side: 2.1" (54mm)
Distance Between Mounting Hole Centers Opposite Side: 3.1" (80mm)
Height from bottom/Crankcase to top of Cylinder Head: 5.4" (138mm)
Width of Cylinder Head: 2.5" (65mm)
Distance Between Muffler Mounting Hole Centers: 1.6" (40mm)

Manuals:

DLE35RA-Manual-English